304 North Cardinal St.
Dorchester Center, MA 02124
For your information: When you buy through links on Mesh Wifi Hub, we may earn a commission.
How To Connect Mesh WiFi To Existing Router ? WiFi systems, on the other hand, are intended to provide you with a reliable internet connection throughout your home. However, there are times when you will discover that your house has an odd layout, revealing that you have a few zones in your home that do not have enough WiFi access. These are known as WiFi Dead Zones, and they may be rather frustrating if you depend on online access on a regular basis.
The WiFi Mesh technology will enable you to solve your home’s WiFi dead zones. WiFi mesh is the most recent technology for upgrading or improving WiFi connection. Of course, the strategy has been utilised in a few specialised domains for a long time, such as military installations. Residential WiFi mesh networks have seen a lot of progress recently.
You may create a mesh network with your current router by switching it to bridge mode.
1-Be sure that your mesh system can connect to a router and support multiple nodes.
2-Connect your “gateway” or “network” node to your router and configure it according to the manufacturer’s instructions. “Bridge mode” is the default setting for your gateway. The gateway’s router operations are disabled in this mode.
Bridge mode may be found under the “advanced networking” section of your device’s app if you don’t see a setup screen. Under Wi-Fi > Advanced Networking > Network Mode, in Google Home, it is accessible.
Set up your nodes according to the app’s setup instructions.
Read Also: How To Create A Mesh Network With Two Routers
The mesh network may be used instead of your modem’s built-in router if you just want to utilise the modem portion of your modem.
1-If your router/modem has any Ethernet cables attached, disconnect them. Allows the router to handle less traffic, thereby preventing signal dropouts.
2-After enabling “bridge mode” in the modem/web router’s portal or management app, review your device’s documentation. This is often available under “Wireless Settings” or in a similar section.
3-If your router doesn’t automatically reboot, manually reboot it.
4-The software will walk you through setting up your mesh network device after you have it connected.
However, it is feasible to add mesh networks to an existing router. Your present router is generally better off being removed or disabled in most cases, but if you need to maintain it, mesh networks are a viable alternative.
In the same way that a radio station’s signal becomes weaker the more away you are from it, traditional routers have a limited range of operation. Wi-Fi extenders may enhance the range of this signal, but it still fades.
“Nodes” are placed around an area, with one “node” linked to your modem acting as a router for the network as a whole. As you move throughout your neighbourhood, the nodes continue to communicate with one another and your device, resulting in a stronger signal. You’ll be able to establish a connection if you arrange the nodes properly.
Double NAT, an acronym for “dual Network Address Translation,” is a possibility when the two are combined. To put it another way, your mesh network and your old-school modem are vying for control of the Internet. To avoid this, one of the two must be deactivated.
Select Firewall > IP Passthrough and input your ATT modem’s access code from the label on your modem. Change the allocation to Passthrough and the IP to DHCP-Dynamic, then restart your modem. Turn off the 2.4 and 5.0 Wi-Fi bands in your home network’s Advanced Settings section. The next step is to disconnect the modem, reset the mesh system, connect to the mesh system through Ethernet port one on the modem, turn everything on, and complete the configuration.
Up to 1,500 square feet may be covered by a single Samsung SmartThings hub. Additional hubs may be added up to 32.