Setek WiFi Extender Factory Reset

For your information: When you buy through links on Mesh Wifi Hub, we may earn a commission.

Have you lost or misplaced the login credentials for your Setek WiFi range extender? To retrieve the login credentials for the Setek WiFi extender, you must do a factory reset on the Setek WiFi extender. Don’t be concerned if you don’t know how to do a Setek factory reset since we’ve got you covered. We are here to assist you. You can find detailed instructions for performing a factory reset on a Setek WiFi extender in this section. Let’s go on with the procedure.

Setek WiFi Range Extender: What You Need to Know

The Setek WiFi range extender is a gadget that allows you to expand the WiFi network in your house or workplace with no effort. To put it simply, it is a remote access extender that is installed between a remote switch and the location where you want improved remote access. A remote-access provider distributes the WiFi signals that are already present from the distant switch. This Setek extender is equipped with four high-speed antennae, which ensures that you get internet speeds of up to 300mbps. This extension allows you to effortlessly connect your smart TV, Firestick, gaming console, and other devices to your network through an Ethernet wire.

Read More: How do I change the WiFi frequency on my PS4?

Simple Guidelines for Setek WiFi Extender Factory Reset

If you have forgotten the password to your Setek WiFi Extender, you may do a factory reset on the device by pressing the Reset button. The factory reset function on the Setek will delete and remove all of the data and apps on the device. It is quite simple to retrieve the password for your Setek WiFi range extender once it has been reset. Refer to the instructions below for how to do a factory reset on your Setek WiFi Extender. The following are the procedures that must be followed:

• As a first step, locate and press the reset button on your Setek WiFi range extender.
• Then, for 10-12 seconds, press and hold the reset button on your range extender.
• Afterwards, you’ll have to wait until the LED power light goes red before using the device.
• To get to the range extender, you’ll have to wait.
• Your computer’s default Internet Protocol (IP) address may be found in the next step. 192.168.50 is the default IP address.
• Next, you’ll need to press the management button on the right-hand side of the screen.
• You’ll be presented with a factory reset button that has been restored. Restore the factory settings by pressing the button.
• As a final step, you’ll be given the option to approve the factory reset through a pop-up message.
• Finally, press the agree button to confirm your changes. To proceed, use the “Continue” button.